Controlling your lighting system
At the centre of our system is the controller.
This comes supplied ready to plug into a standard UK electrical socket. If no socket is available then a qualified electrician is required to provide an available power service and connect the controller.
The controller has a light sensor so it is important to place it outside and ideally not in a shaded area which does not enjoy normal daylight. It is also advised to make sure that the controller is placed where it can not be affected by other lights in the area (see example).
Our controllers are weather proof and have been tested in extreme environmental conditions of salted air, low and high temperatures.
All power from the controller is 12volt allowing safe DIY installation of our lights using simple connection and running wiring safely. Qualified electrician is not required for this part of installation.